Design And Propose The Solution For Cellular Network.

A configurable SRAM compiler written in Python to tile the bit cells and address decoder blocks, extract the Verilog and parasitic RC models, and generate the GDS2 block database. The project should leverage the "openRAM" open source code as much as possible to achieve the above objectives.

I need someone who can build a prototype for a Sitara SoC based streaming audio amplifier project. You must have a spectrum/distortion analyzer. Deliverable: Prototype hardware with firmware/software -Receive streaming Audio stack in ARM -Audio is output thru PRU-ICSS in Sitara via 10 bit PWM / 44 khz -integrated small power amplifier

Searching for a specialist who has a little bit of free time and can design a scheme of properly working AC/DC adaptor (output 12VDC=2A) on Altium (included library and Gerber files). As the confirmation, that the adaptor works properly you will be asked a video demonstration, also the results of measurements. If some materials are needed for testing the scheme - we'll cover the cost. Find attached the photo of AC adaptor example.

Arduino Bluetooth Controlled Car

I'm looking for an expert in Barcode Scan and electronics, I need a box with barcode readers inside this box to be able to read objects automatically. When I put one object into this box, this object should be identified using a barcode. This box should be able to identify this barcode in any position.

Searching for a specialist who has a little bit of free time and can design a scheme of properly working Address engine control unit with integrated LIFEPO4 battery (with protocol management and testing) on Altium (included library and Gerber files). As the confirmation, that the module works properly you will be asked a video demonstration, also the results of testing. If some materials are needed for testing the scheme - we'll cover the cost.

Arduino Voice Controlled Car At Home

Arduino Obstacle Avoiding Car At Home

need to make a pcb shield for stm32 hz45zi-q board connection following modules 1) max 3865 temperature module ( 2 sets ) 2) Rdl 4-20 ma loop transmitter module ( with power connections ) 3) Eeprom 4) Rtc battery 5) memory card

electronics write a firmware in c ARM for a led display contact for more details

I want layout of a circuit to be made on tanner (ledit).

I need good expert who can do Digital Signal processing or signal and systems task

I am looking for someone to design a custom raspberry pi carrier board. The carrier board will have the following: 1. For use with the Raspberry Pi Compute Module 3+ 2. Solid state relay for control 3. 5v Barrel Jack connected for power 4. Wi-Fi Module 5. Ethernet RJ45 Connection 6. HDMI Connection 7. 1xUSB 3.0 Connection 8. Standard 40 pin GPIO Header The form factor of the board is important. Details Below: 1. Ethernet RJ45, Barrel Jack Connector and…

Electrical engineering design and review for a camp project for the oil and gas industry.

a) Network Configuration The overall infrastructure and the components of the international and national networks to enable the provision of the telecommunication services. The description will include the network management capabilities, routing plan, transmission plan, signalling plan and diversity plans. b) Network Facilities The planned locations and technical details of its network such as international frontier stations and gateways, local/tandem/trunk exchanges, land lines, cable ducts, radio base station sites and other equipment to be installed and frequency spectrum to be…