Web|Software|Desktop|Mobile developers. Find a remote job.

I am looking for an Electrical Engineer who has good knowledge about electrical optimization. I need to do a project about Microgrids using MOPSO.

Busco un ingeniero eléctrico que tenga buenos conocimientos sobre optimización eléctrica. Necesito hacer un proyecto sobre Micro

Dear, I have pdf i want to convert the pdf to excel

We are planning to build a data center with a large power capacity (up to 40MW), and we are looking for an expert who can make electrical designs and assist us in communicating with power suppliers. Expected deliverables for our project include: - Make electrical designs for our data center. We need an expert to advise on the power capacity and input voltage required by our operation, power distribution and conversion (from high voltage to low voltage), electrical take-offs, server…

Hii.. we need a person who can design a PCB for our college project. (minimum requirement) input voltage 170-300V ,47-63hz output voltage 54.6V ±0.2 output current 6A ±0.2A the charger will charge the lithium-ion battery, need improvement in input and output to charge ev faster and better.. without damaging the battery. Note : Need Person with long term Mindset.

We Need Person or organization with best knowledge on power electronics and work with our team to help changing the future

Power drive controller for 15kW three phase induction motor

need PDF converter to convert PDF file into words

I need traing on control and automation of Motor drives and power Electronics using various control tecniques for 10 days in Matlab simulink.So I will able to generate all control schemes by myself.

Project Report Format:- • Table of Contents • Introduction • Objective/Abstract • Literature Review • Methodology • Observations/Findings • Recommendations/Suggestions o Cost-Benefit analysis • Conclusion • Future Scope • References Format for Presentation:- • Introduction • Agenda/Objective • Methodology • Observations • Recommendations/Suggestions o Cost-Benefit Analysis • Conclusion • Future Scope • References • Thank You Separate File:- • Observations/Findings • Recommendations/Suggestions o Cost-Benefit analysis

I have a TI TMS320f28335 experimenter kit. I want to trigger 8 igbts. I need someone who has done some work on this kit before. I have tried a bootstrap circuit along with TI gate driver UCC21520EVM-286 but couldn't succeed and broke three drivers. I would prefer a freelancer who has this kit and have experience working on it.

I need a powerful converter that can perform the following conversions offline: PDF to Office Files (Word,Excel, PPT), HTML, PDF/A and Word, Excel, PPT, HTML to PDF. It should be written in C, C++, C# or QT. The converter does not need to have a GUI. However, I need full access to the source code.

Need a Power convertor circuit with below technical details-: Technical Data of Job work-: Input Power - 440V/50Hz Output Power - 40KW Generator Freq. - 40KHz Min. Output Voltage - 40-150 KV Max.Output Current - 500mA

I need to write a SCI paper on Multilevel Inverter THD Optimization and hardware support with Hybrid Algorithm on Matlab.

Design a linear array of 8 microstrip rectangular patch antennas, including the microstrip line corporate feeding network, operating at 2.52 GHz. The single source of this array is connected to the microstrip feeding network via a 50 Ω port. For the design, choose an appropriate substrate from Rogers Corporation RT/Duroid® Laminates (https://rogerscorp.com/advanced-connectivity-solutions/rt-duroid-laminates). All microstrip patch antennas should have an input impedance of ???? = 50 + ?0 Ω and its microstrip-line feed should have a characteristic impedance of 50 Ω.…